Application Instructions

Cold Peel Printing Specialists - BERDA.COM

for COLD PEEL TRANSFERS

IMPORTANT TIP: Always do a test print on a piece of scrap material before starting a production run. Use one of the extra transfers and cut it into pieces for your test.

"Learn More About It"
Read our Digital Web Book:
"How to apply Cold Peel Transfers."

File Size: 1.9 MB

STEP 1.	Set heat press Temperature to 360°.
	(Let your heat press warm up for at least 10 minutes)

STEP 2.	Set Pressure to Medium/Firm.

STEP 3.	Set Time for 10 Seconds.

STEP 4.	Pre-heat the Heat Press Platen (the bottom pad) for 60 Seconds.
	(This is a very important step!)

STEP 5.	Pre-heat garment for 6 Seconds.
	(This removes moisture from the garment--a necessary step.)

STEP 6.	Place transfer on the garment and press for 10 Seconds.

STEP 7.	Open heat press SLOWLY! and do not touch garment or transfer for at least 30 Seconds*. Then, carefully move garment to a table to completely cool, then slowly peel the transfer off.

An alternate cool-down method is to place a metal cookie sheet or similar metal plate over the transfer after SLOWLY opening the heat press. Place metal sheet over the transfer for 5-7 Seconds and this will absorb the heat faster. Do not peel transfer until the garment and transfer are cold.

Ready to Order? or Have Questions? Call 1-800-293-7080.

BERDA®, BERDA CompuGraphix® and The USA's Online
T-Shirt Printing Shop® are registered trademarks of BERDA CompuGraphix.
America's T-Shirt Printer™ is a trademark of BERDA CompuGraphix.
No portions of this site may be duplicated without permission of BERDA CompuGraphix.

Copyright © 1998-2009 · berda.com · BERDA CompuGraphix