PLYFOAM
SWINGING COOLER AND
FREEZER DOORS "ADS-106"

Cooler Door Shown
Right Hand Swing

• White Metal Clad Finish
• Five Year Warranty

• Supply where indicated on plans Jamison Plyfoam ® Cooler Door.
• Door panel to be constructed of #26 gauge white pre-painted stucco embossed steel pans front and back with reinforcement for hardware attachment.
• Frame metal clad on all exposed surfaces with #26 gauge white pre-painted stucco embossed steel.
• Door to be filled with 4" (101.6mm) of Jamifoam non-CFC polyurethane insulation with an R value of 28 at 40° F (4½°C).
• Gasket at sides and head of door lip to be grease resistant synthetic skin with resilient sponge core, sill gasket to be sweep type.
• Hardware to have protective coating against corrosion and to consist of adjustable spring hinges and safety release type fastener (permits door to be opened from inside even though padlocked on front). (Note: For door sizes over 5'0" (1524mm) wide, specify - door to be equipped with safety release device.)

Freezer door specifications to be same as cooler door except for these substitutions and additions:

• Supply where indicated on plans Jamison Plyfoam ® Freezer Door.
• All metal cladding on warm side of door (front-unless otherwise specified) and frame shall be applied with all seams and penetrating bolts sealed.
• Provide Frostop heater cables in the sides, head, and sill of the frame at gasket contact areas. Complete device to be assembled, ready for connection to 120 volt, 60 Hertz (50 Hertz available), single phase AC line.

1. When cold room temperature is below -20° F (-29°C)  or temperature difference is more than 90° F (4½°C), contact BMIL International.
2. If freezer door must be mounted in freezer room, please contact BMIL International for recommendations.

1. Metal cladding can be stainless steel, stucco aluminum, galvanized, or galvanized steel painted to meet specifications.
2. Kick-plates -- door and/or frame protected partial height (specify finish).
3. If doors to be used in meat processing plants subject to federal and state inspection, metal cladding to be applied per M.I.D. requirements.
4. Deep jambs/inside trim.
5. 6" (152.4mm) of insulation for freezer door (R value of 42).
6. Door closer.
7. View Windows: 12" x 14" (304.8mm x 355.6mm) sealed glass unit.
   a. Cooler Door - 2 layer, 1" (25.4mm) thick.
   b. Freezer Door - 3 layer, 1" (25.4mm) thick with 120 V.A.C. heat film (other voltages available).