Right Hand Swing Shown

• Plastic Door in Stainless
  Steel Clad Casing Frame.
• Three Year Warranty

• Supply where indicated on plans Jamison Jamolite® II Cooler Door. Door panel to consist of two pans bonded together with polyester resin. Each pan to have an outer layer of polyester plastic with white pigment, balance of pan to consist of glass fiber reinforced polyester plastic. Door panel to have sufficient blocking for hardware attachment.
• Door panel to be filled with 4" (101.6mm) of non-CFC polyurethane insulation with an R value of 28 at 40° F (4˝°C) . Insulation to adhere to the inner and outer pans to achieve maximum unit rigidity.
• Casing frame metal clad on all exposed surfaces with #24 gauge stainless steel. 
• Gasket at sides and head of door lip to be grease resistant synthetic skin with resilient sponge core, sill gasket to be sweep type.
• Hardware to consist of chrome plated safety release fastener (permits door to be opened from inside even though padlocked on front) and bright anodized finish cam lift hinges.

Freezer door specifications to be same as cooler door except for these substitutions and additions:

• Supply where indicated on plans Jamison Jamolite ® II Freezer Door.
• Casing frame metal clad on all exposed surfaces with #24 gauge stainless steel. Metal cladding shall be applied with all seems soldered and penetrating bolts sealed.
• Provide heater cables in the sides and head of the frame and the bottom of the door at gasket contact areas. Heating cable to be assembled, ready for connection to 120 volt, 60 Hertz (50 Hertz available), single phase AC line.

1. When cold room temperature is below -20° F (-29°C). Or temperature difference is more than 90° F (50°F), contact BMIL International.
2. If freezer door must be mounted in freezer room, please contact BMIL International for recommendations.

1. Freezer Door:
   a. 6" (152.4mm) insulation (R value 42).
   b. Heater cables in sides, head and sill of frame.
2. Colors available - pigment of door to be one of the four optional colors other than white. (JD - Ivory, JD - Blue, JD -Salmon, and JD - Blue-Green).
3. Metal Cladding options:
   a. Frame-galvanized or painted steel to match door color.
   b. Kick-plates-door and/or frame protected partial height with galvanized or stainless steel (specify finish).
4. Corrosive protected hardware.
5. Door closer-top mounted, painted to match door color or bright anodized finish or chrome finish.
6. If doors to be used in meat processing plants subject to federal and state inspection, metal cladding to be applied per M.I.D. requirements.
7. View Windows: (contact factory for specific recommendations.) 12" x 14" (304.8mm x 355.6mm) sealed glass unit.
   a. Cooler Door - 2 layer, 1" (25.4mm) thick.
   b. Freezer Door - 3 layer, 1" (25.4mm)  thick with 120 V.A.C. heat film (other voltages available).
8. Jambs-specify wall thickness on plans.
9. Inside Trim - 1-1/2" by 5-1/2" (38.1mm x 139.7mm)
10. Other Designs.
    a. High sill (note-high sill freezer door has heater cable 4 sides of frame.)
    b. Track door-frame provided with provisions for meat rail passage.
    c. Blast Freezer.
11. Chrome plated cam lift hinges.