PACKAGED CHILLERS

Applications:

Standard Features All Models

• Stainless steel brazed plate evaporator insulated with a foam blanket, and secured in a steel bracket
• Multiple compressor models have equally divided independent components balanced to each circuit
• R-22 charged, leak tested refrigerant circuit with thermal expansion valve, liquid solenoid, fully insulated suction lines, sight glass, liquid filter/drier
• Sturdy sheet metal cabinet, finished with sandstone colored industrial acrylic paint
• Rust resistant, high CFM, aluminum condenser fan blades (air cooled)
• Direct drive condenser fan motor (air cooled)
• Condensers: copper tube / aluminum fin (air cooled), cupro-nickel tubes (water cooled)
• Hot gas by-pass capacity control that also adds extra freeze protection
• 24V control transformer
• Return fluid temperature sensing thermostat
• Low refrigerant pressure freeze control w/ time delay for start up
• High refrigerant pressure control
• Single phase compressor "hard start" capacitors
• Compressor motor and system water pump contactors
• On/Off switch for control circuit shutdown
• Compressor "short cycle" time delay
• High efficiency hermetic compressors
• Compressor crankcase heater
• Suction accumulator (air cooled models only)
• LED 24V powered thermometers on water inlet and outlet

Standard Features Tank Models

• All standard features listed above +
• Re-circulating pump for tank operation with cleanable strainer
• Insulated, stainless, high capacity storage tank suitable for glycol applications
• Tank pressure relief valve, vent and drain connections

Options All Models

• Refrigerant suction / discharge gauges
• Extended compressor warranty (+ 4 years)
• Condenser water regulating valves, factory installed (water cooled)
• Indicator lights
• Alarm circuit
• Blower type condenser fan (forward curved)
• Manual reset freeze thermostat
• Heat recovery unit with pump
• Coastal protection package
• Heavy duty fused disconnect
• Pressure controlled condenser fan cycling
• Variable speed condenser fan control
• Flooded condenser control with receiver
• Factory installed heat tape freeze protection thermostatically controlled
• Special piping for de-ionized and reverse osmosis water systems (Consult BMIL International For Special Piping)
• Liquid injection compressor cooling (for leaving water temperatures above 65�F)
• Casters, factory mounted
• System re-circulating pump, factory installed
• Alternate compressor manufacturers (consult BMIL International for availability)

Options Tank Models

• All standard options above +
• Storage tank sight glass with isolation valves
• Tank low liquid level alarm

Copyright 2009, BMIL Technologies, LLC.,. All rights reserved
4915 Arendell St., #313, Morehead City, NC 28557, 252-727-0994
Names and Logos are registered Trademarks of their respective companies.
Send comments on this web site to bmil@bmil.com. Last revised January 17, 1997.